Hello,

 

The following is a recap of our meetings today:

 

*	UDR indicated a preference for a Random Ashlar pattern while TOA
expressed an interest in a Ledgestone pattern.  There is a slight increase
in the cost of Ledgestone since more cutting is required to produce the
narrower (in height) pieces.  There may also be a slight increase in
installation costs.  However, the Ledgestone pattern can provide a more
contemporary look.
*	Denser stones were selected to reduce the amount of water absorption
and staining.  The chart below shows the denser selections.
*	UDR would like to do mockups with approximately 30 square foot each
for 4 different stone types.  This will provide a better representation of
color range and also demonstrate thin veneer installed on a curved surface.
*	As you can see from the table below we now have 7 stones that have
been selected.

 


Stone Type

TOA Selection

TOA Selection

Denser Stone

Comments


Tuscany

X

 

 

Quarry Chop


Suttermill

X

 

X

 


Aspenbark

X

 

X

 


Greycastle

X

X

X

TOA felt this was too light and looked like concrete


Coalcreek

X

X

X

 


Autumn Buckskin Ledge

 

X

 

TOA raised concern that this stone may oxidize and create red streaks


Valley Blend Mix

 

X

X

 

 

Please consider this information and then perhaps we should meet again to
review the samples.

 

Thank you,

Bob

 



 

Bob Baumann

 

214.206.1111 tel                 4310 Wiley Post Road, Suite 104

214.621.0070 cel                Addison, Texas 75001

214.774.4832 fax             www.veracreek.com